ALDI FERREX 705715 User Manual page 14

2) Remove the clamp (3) from the clamp holder
and insert the HSS drill bit (not supplied) to be
sharpened. Rotate the clamping ring (5) in a
clockwise direction to tighten the clamp lightly to
leave the drill bit still free to move (See Fig. B3, B4).
3) Place the clamp containing your drill bit into the
setting slot (4) , using the grooves in the side to
lower it in correctly (See Fig. B5).
4) Move the drill bit forward so that it lays in the "V"
guide (6) and touches the metal end stop (See Fig.
B5).
5) Turn the drill bit until the "V" guide (6) fully drops
over it. All four drill bit corners should now be
touching the "V" guide (6) sides.
6) Ensure that the drill and holder are fully down
in the setting slot. With the drill bit in this position,
tighten the clamping ring (5) in a clockwise
direction (See Fig. B6).
7) Lift up the "V" guide (6) and remove the clamp
and drill bit (See Fig. B7).
8) Transfer the clamp and drill bit into the clamp
holder (See Fig. B8).
9) Insert the plug into the mains power socket and
switch on the power. Move the on/off switch (10)
to the "I" position to turn the sharpener on.
10) Move the clamp holder from side to side as
indicated by the arrow on the sharpener, securing
with light finger pressure (See Fig. B9).
11) Switch the device off. Remove drill bit and
clamp and turn over. Repeat Step 10.
B7.
11
e-mail: info.aldi@positecgroup.com
MODEL No.: BDS651
B8.
• 05/2021 • 705715
65 W Multifunctional sharpener
B5.
B6.
B9.
AFTER SALES SUPPORT
1300 889 028
(toll free)