Stap Errors - BRECHTEL STAP 9406 Instrument Manual

9 STAP Errors

Each STAP error is assigned a bit in the STAP ERROR number. Convert the STAP ERROR
number to binary to check the bits. If an error is occuring, the bit for that error will be 1
instead of 0.
Bit Number ERROR
1 EPROM ERROR
2 BAD Stored Value
3 Clock - Check time
4 Clock ERROR
5 SD Card ERROR
6 SD Format not FAT32
7 SD Card Space ERROR
8 Bad Thermistor ERR
9 PUMP MAXED OUT ERR
10 RED LED ERROR
11 GREEN LED ERROR
12 BLUE LED ERROR
13 BLACK NOISE ERROR
One common error in the STAP is "BAD Stored Value" error. This error shows up if there
was trouble with the previous filter initialization. The initialization readings are stored
in the EEPROM after initialization. If the readings are too low, the "BAD Stored Value"
error will appear at the next power up because the EEPROM values are checked when
they are read at power up.
83-00036-01A STAP 9406
9 STAP Errors
Page 42 of 46