Computer Connections; Mounting - BRECHTEL STAP 9406 Instrument Manual

6 System Setup
The SPI bus connector item 4 is not used.

Computer Connections

The UAV Reader interface software requires a USB connection between the control com-
puter and the USB Port on the STAP main board as shown in figure 6. The UAV Reader
software may be purchased as an accessory to the STAP installed on a ruggedized tablet,
contact BRECHTEL for information.
Connect the USB cable prior to running the software. Do not disconnect the USB cable
while the software is running.
The RS232 port, item 3 in figure 6, may be used to establish serial communication with
the STAP from a user-supplied computer. An interface cable with a serial connector is
provided in the STAP ship kit. The port configuration and commands available are de-
scribed later in this manual.

6.6 Mounting

The STAP is shipped integrated with a mounting bracket that has tabs with holes for
mounting bolts. See figures below for detailed mounting dimensions of the various items.
Alternatively, the STAP can simply be placed on a table top. The mounting tabs may be
bent to provide mounting flexibility. Threaded standoffs may also be used to mount the
STAP to a shelf. Be sure to employ at least three hard mounting points to properly sup-
port the STAP. Bolts should not extend into the cover so much that they would interfere
with the main control board connections. Mount the unit for easy access to the filter
changing bolts to facilitate filter changes.
83-00036-01A STAP 9406 Page 20 of 46