Related Manuals for FAST CLEAN Barracuda WSC26
Summary of Contents for FAST CLEAN Barracuda WSC26
- Page 1 FAST CLEAN OWNER’S MANUAL Barracuda WSC26 Battery Powered Automatic Walk-behind Scrubber FAST CLEAN, INC. 210 Southwest Ave. Tallmadge OH 44278 (833) 801-2358 sales@fastclean.com www.fastclean.com...
-
Page 2: Table Of Contents
Barracuda WSC26 Before operation or use of this machine, please carefully Table of Contents read this manual. Precautions ............... 3 When ordering the replacement parts, please refer to the spare and accessory parts manual attached to the Basic Safety Instructions ........... 3 machine. -
Page 3: Precautions
Barracuda WSC26 Precautions 7. Please wear anti-skid shoes This machine is intended for indoor hard floor use only. Maintenance Instructions Please use the suggested scouring pads and brushes as well as the manufacturer recommended cleaning chem- All maintenance should be carried out by trained, qualified icals for this machine. -
Page 4: Machine Diagram
Barracuda WSC26 Machine Diagram Machine Unpackaging 1. After receiving, carefully inspect whether there is damage to the crate of the machine. If there is, please immediately notify carrier. 2. Check the freight list. If there is any omission, please contact the distributor. Your crate should contain: ... -
Page 5: Scrub Brush & Scrub Pad Recommendations
Barracuda WSC26 Paint a thin layer of metal-free lubricating oil or protective Scrub Brush/Scrub Pad Installation spray on the connected wiring to avoid battery corrosion. 1. Stop and place the machine on the level ground and After the batteries are installed, please check the power take out the start key. -
Page 6: Running The Machine
Barracuda WSC26 above 80% you batteries do not need to be charged yet. In Running the Machine order to prolong the life of the batteries, do not let them run completely down. Warning: Fire or explosion hazard. Do not attempt to vac up flammable or corrosive liquids, or reactive metals. -
Page 7: Drainage Of Recovery Tank
Barracuda WSC26 4. Dismantle and wash the floating filter screen in the recovery tank. Dry and replace when finished. Inspect 4. When charging, please open the recovery tank to for corrosion and wear. Replace filter if necessary. facilitate ventilation. 5. Allow all waste and rinse water to drain from recovery 5. -
Page 8: Machine Storage
Barracuda WSC26 3. Inspect battery wiring and make sure it is in proper in), the carbon brush needs to be replaced. Please contact position and in good condition. your local dealer or authorized service center. Machine Storage 4. Check and clean the cover of the recovery tank and replace it if there is any damage to the tank or seal. -
Page 9: Specifications
Barracuda WSC26 Inspect vac hose and remove The vac hose is blocked. clogs. Vac motor has failed. Please contact service center. Run time has shortened. Batteries have worn out. Replace batteries. Replace battery charge or contact Battery charger has failed.
Need help?
Do you have a question about the Barracuda WSC26 and is the answer not in the manual?
Questions and answers