FAST CLEAN SS WSC21 Owner's Manual

Battery powered automatic walk-behind scrubber

Advertisement

Quick Links

FAST
CLEAN
OWNER'S MANUAL
SS WSC21
Battery Powered Automatic
Walk-behind Scrubber
FAST CLEAN, INC.
210 Southwest Ave. Tallmadge OH 44278
(833) 801-2358
sales@fastclean.com www.fastclean.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SS WSC21 and is the answer not in the manual?

Questions and answers

Summary of Contents for FAST CLEAN SS WSC21

  • Page 1 FAST CLEAN OWNER’S MANUAL SS WSC21 Battery Powered Automatic Walk-behind Scrubber FAST CLEAN, INC. 210 Southwest Ave. Tallmadge OH 44278 (833) 801-2358 sales@fastclean.com www.fastclean.com...
  • Page 2: Table Of Contents

    SS WSC21 Before operation or use of this machine, please carefully Table of Contents read this manual. Precautions ..............3 When ordering the replacement parts, please refer to the spare and accessory parts manual attached to the Basic Safety Instructions ........... 3 machine.
  • Page 3: Precautions

    SS WSC21 Precautions 6. Do not allow children on or around the machine. This machine is intended for indoor hard floors only. 7. Please wear anti-skid shoes. Please use the suggested scrubbing pads and brushes as well as the manufacturer recommended cleaning chem- Maintenance Instructions icals suitable for this machine.
  • Page 4: Machine Diagram

    SS WSC21 1. Forward/Reverse (Manual) 2. Brush On/Off Machine Diagram 3. Power On/Off (Key switch) 4. Vac On/Off 5. Battery Power Indicator Machine Unpackaging 1. After receiving, please inspect whether there is damage to the packing crate of the machine. If there is, please immediately notify carrier.
  • Page 5: Battery Power Gauge

    SS WSC21 Proper ventilation is recommended in the area where batteries are being charged. Be careful that the poles are Warning! Fire or explosion hazard. The batteries release connected hydrogen. Please keep away from spark or open flame. Do properly! not place tools, metal shavings or other metal instruments on batteries as this could cause an electrical arc.
  • Page 6: Scrub Brush/Scrub Pad Installation

    SS WSC21 1. Connect vac hose into port. 1. Park the machine on level ground, turn off power switch 2. Adjust squeegee pitch by turning knob. and take out the start key. Scrub Brush and Pad Driver Installation 2. Lower squeegee assembly to operating position by pulling down the lever on the back side.
  • Page 7: Starting The Machine

    SS WSC21 and water for use in scrubbing. 5. We strongly recommend using only low foam detergents in the scrubber. Consult your local dealer for details. If 2. Use only low foam detergents recommended by you are getting too much foam while cleaning, we the manufacturer.
  • Page 8: Drainage Of Recovery Tank

    SS WSC21 9. Rinse brushes or scrub pads. Replace if they are worn Warning: Electric shock hazard. Disconnect the battery out. wiring before performing electrical maintenance on the machine. 10. Charge the batteries. To prolong the life of the 1. Remove the filter of the solution tank clean the filter batteries and ensure the optimum efficiency of the screen.
  • Page 9: Troubleshooting

    SS WSC21 Troubleshooting Batteries have no power. Charge batteries. The machine will not operate. Batteries will not charge. Replace batteries Battery wiring is not Check battery wiring for loose connected. connection. Tighten if needed. Fuse has blown. Replace the fuse.
  • Page 10: Specifications

    SS WSC21 Specifications Specification Unit SS WSC21 Specification Unit SS WSC21 Voltage 24 (2 x 12) Brush speed Amperage Brush pressure lb/in Run Time hours 4 (approx.) Vac motor power Cleaning width Drive motor power Vacuuming width Solution Tank Capacity...

Table of Contents