Related Manuals for FAST CLEAN Cobra RSC34
Summary of Contents for FAST CLEAN Cobra RSC34
- Page 1 FAST CLEAN OWNER’S MANUAL Cobra RSC34 Battery Powered Automatic Rider Scrubber FAST CLEAN, INC. 210 Southwest Ave. Tallmadge OH 44278 (833) 801-2358 sales@fastclean.com www.fastclean.com...
-
Page 2: Table Of Contents
Cobra RSC34 Before operation or use of this machine, please carefully read this manual. Table of Contents When ordering the replacement parts, please refer to the spare and accessory parts manual attached to the Precautions ............... 3 machine. Before matching parts or accessories, please first determine your machine model and serial number. -
Page 3: Precautions
Cobra RSC34 Precautions Warning! To avoid injury, turn off the power before performing routine maintenance on the machine. It is also This machine is intended for indoor hard floors only. recommended to disconnect the battery wiring before Please use the suggested scrubbing pads and brushes as performing any electrical maintenance. -
Page 4: Battery Installation & Charging
Your crate should contain: Before connecting the batteries, please ensure whether Main unit: 1 Cobra RSC34 scrubber the electrodes and terminals are clean. Use terminal 6V battery: 4 wet, maintenance free batteries ... -
Page 5: Squeegee Installation
Cobra RSC34 7. The charger will automatically begin charging, and will 4. Align the pad driver/scrub brush installation studs at the automatically turn off when batteries are fully charged. motor drive disc latches. Brushes/pad drivers simply twist on (clockwise) or off (counterclockwise). -
Page 6: Control Panel
Cobra RSC34 □ Check the condition of the rear squeegee and reposition Control Panel Operations or replace if it is worn. Always make sure squeegee is clean before starting. □ Check the condition of the skirt around the scrub deck. -
Page 7: Battery Power Gauge
Cobra RSC34 6. Please slow down on slopes and slippery floors, or Note: To extend battery life, do not charge the batteries when turning. until the machine has been run for 30min. 7. If the foam is excessive, add a manufacturer-recom-... -
Page 8: Machine Storage
Cobra RSC34 5. Remove the scrub brushes or pads and rinse. Inspect 7. Check whether the machine leaks. for wear, and replace brushes if they are worn out. Pads may be flipped over and reused until both sides are worn. -
Page 9: Scrub Brush & Pad Recommendations
Cobra RSC34 Scrub Brush and Scrub Pad Recommendations To ensure the optimum efficiency, please use the correct type of brush or pad for the surface you are cleaning. Please read the following: Soft nylon brush (white) – Recommended for use on coated floors to avoid causing scratches or wear on the surface. -
Page 10: Warranty Card
Cobra RSC34 Warranty Card (please fill out and return to dealer) Name Phone # Address City State Purchase Date Invoice # Model # Serial # Local Dealer Local Dealer City/State Warranty provided with purchase invoice.
Need help?
Do you have a question about the Cobra RSC34 and is the answer not in the manual?
Questions and answers