Challenger RSS35 Before operation or use of this machine, please carefully Table of Contents read this manual. Precautions ............... 3 When ordering the replacement parts, please refer to the spare and accessory parts manual attached to the Basic Safety Instructions ........... 3 machine.
Challenger RSS35 Precautions Warning! To avoid injury, turn off the power before performing routine maintenance on the machine. It is also This machine is intended for indoor hard floors only. recommended to disconnect the battery wiring before Please use the suggested scrubbing pads and brushes as performing any electrical maintenance.
Your crate should contain: cleaning fluid and wire brush as required. Paint a thin layer of metal-free lubricating oil or protective Main unit: 1 Challenger RSS35 scrubber spray on the connected wiring to avoid battery corrosion. 6V batteries: 4 wet, maintenance free batteries ...
Challenger RSS35 brushes. Bristles must meet the floor. If not, adjust the 5. Insert the AC power cord of the charger into outlet or position of the brush closer to the ground. other power source. 6. Insert the DC cable of the charger into the battery charging socket on the rear panel of the recovery tank.
Challenger RSS35 Starting the machine Control Panel Operations 1. Turn the main power key to the ON position. 2. Turn on solution flow (See #3 on Control Panel). 3. Turn on the brushes, then turn on vacuum. (See #7 on Control Panel).
Challenger RSS35 8. On especially dirty floors we recommend a two-pass Cleaning the Recovery Tank system. Turn off vac system for the first pass. Deposit detergent and let sit for 3-5 min. Then lower the 1. Drive the scrubber over to the maintenance area, squeegee, turn on the vac and run the second pass.
Challenger RSS35 7. Wipe the machine with multipurpose cleaning agent and Quarterly Maintenance (or after 250 hours) wet cloth. Check the carbon brush wear of the drive motor (drive Do not use steam cleaner or pressure washer to clean model), vacuum motor, and brush motor. When the length of the carbon brush is work for less than 10mm (3/8”), the...
Challenger RSS35 Troubleshooting Batteries have no power. Charge batteries. The machine will not operate. Batteries will not charge. Replace batteries Battery wiring is not Check battery wiring for loose connected. connection. Tighten if needed. Fuse has blown. Replace the fuse.
Challenger RSS35 Warranty Card (please fill out and return to dealer) Name Phone # Address City State Purchase Date Invoice # Model # Serial # Local Dealer Local Dealer City/State Warranty provided with purchase invoice.
Need help?
Do you have a question about the Challenger RSS35 and is the answer not in the manual?
Questions and answers