Related Manuals for FAST CLEAN ZL1 WSC14
Summary of Contents for FAST CLEAN ZL1 WSC14
- Page 1 FAST CLEAN OWNER’S MANUAL ZL1 WSC14 Battery Powered Automatic Walk-behind Scrubber FAST CLEAN, INC. 210 Southwest Ave. Tallmadge OH 44278 (833) 801-2358 sales@fastclean.com www.fastclean.com...
-
Page 2: Table Of Contents
ZL1 WSC14 NOTICE: Descriptions, features and specifications of the Table of Contents machine in this publication are not binding, and are subject to change without notice. The manufacturer reserves the General Operating Instructions ......... 2 right to make necessary changes and modifications as conditions warrant. -
Page 3: User Responsibility
ZL1 WSC14 is designed for scrubbing and vacuuming indoor hard floor surfaces. (It is not intended for parking ZL1 WSC14 comes standard with two 12 volt lead acid lots, sidewalks, or other outdoor areas). Please follow the (wet) rechargeable batteries, and 24V/15A battery charger. -
Page 4: Recharging The Batteries
Check the battery power level. If anything less than 4 (full charge) is indicated, please charge batteries before using Operation Controls for ZL1 WSC14 the machine. Note: Make sure that the battery charger matches the installed batteries, both in capacity and in type. -
Page 5: Machine Diagram
ZL1 WSC14 1. Adjust the handlebar by pulling up on the lever on the Turn Power On/Off back right. (See top photo and #2 in machine diagram). Adjust to comfortable working height. Turn Solution Flow On/Off 2. Mount the recovery tank on... -
Page 6: Operating The Machine
ZL1 WSC14 Warning: Do not use a high foaming agent, or too high a concentration of cleaning chemical as this could cause Routine Maintenance Instructions excessive foam buildup in the machine, which could Cleaning the Machine After Use: damage the vac motor. - Page 7 ZL1 WSC14 2. Lift the machine (see photo 1) Showing all parts of squeegee assembly: 3. Remove the hose from the squeegee assembly (see photo 2). 4. Loosen the 2 screws as shown in the picture to remove the squeegee (see photo 3).
-
Page 8: Troubleshooting
ZL1 WSC14 4. Allow tank to drain and air dry. Machine Specifications 5. Reinstall the plug. Specifications Unit ZL1 WSC14 Brush Recommendations: Voltage 24V (2 x 12V) Polypropylene Brush（PPL） Amps This general purpose scrub brush is recommended for all floor types and offers good resistance to wear and to hot Run Time 2 (approx.) -
Page 9: Warranty Card
ZL1 WSC14 Detergent in machine is not aggressive Try using a different detergent, or use a enough to remove soil from floor. two-pass cleaning system and allow detergent to sit on floor surface for 3-5 minutes before second pass. (Consult cleaning chemical manufacturer or local dealer if you have questions).
Need help?
Do you have a question about the ZL1 WSC14 and is the answer not in the manual?
Questions and answers