Advertisement
Quick Links
Advertisement
Related Manuals for ASEPT nemco UNI-2
Summary of Contents for ASEPT nemco UNI-2
- Page 1 UNI DISPENSERS MODEL UNI-2, UNI-3 User Manual 10950, 10951...
- Page 2 UNI Dispensers Complete Pump 9851 (Natural Dome) Complete Pump 9855 (Black Dome) Natural Dome 7299 Black Dome 8215 Pump Housing 9720 Dome Clip 7868 Nozzle 8651 Valve 9683 Brush 7615 Designed for use with standard 1½ ,1 or 3/4 gallon pouched condiments and toppings. Pumps attach to 16mm fitments in pouches.
-
Page 3: Pump Cleaning
Safety All components must be cleaned before first use. According to food and safety IMPORTANT Clean, rinse, sanitize, regulations, most foods must be and dry parts at a minimum stored and/or served at certain of every 24 hours. Always temperatures or they could comply with local sanitization become hazardous. - Page 4 Assembly Mount the nozzle onto the end of the pump housing. Bend the outer portion of the nozzle inside out. Insert into opening. Tab of nozzle faces towards housing. Flip the outer portion of the nozzle over the end of tube. Insert dome into the pump housing.
- Page 5 Insert valve into the bottom of the pump housing. Wrap the flaps on the side of valve onto the pair of pegs on the pump housing. TIP: Lubricate parts with clean water to ease fitting. Connect pump to pouch Put new pouch on countertop with fitment facing up.
-
Page 6: Tips And Troubleshooting
Insert the lid Hold the lever up while inserting lid tabs into slots in back of dispenser shroud. Prime pump Press the pump lever several times until food is visible in discharge tube. Tips & Troubleshooting Product not dispensing? Make sure dome is primed properly. Prevent leaks: Ensure that dome is pushed fully into pump housing. - Page 7 Setting the Portion Remove locking washer Use a flathead screwdriver to pry off the locking washer from the pin at the end of the link arms. Keep locking washer for step 4. Remove pin Slide the pin out from the pair of link arms and handle holes.
- Page 8 ASEPT General Warranty Liability for defects incorrect erection or faulty repair by the Customer, Should the products, as delivered, within one or by alterations carried out without the Supplier’s (1) year from delivery be shown to be defective consent in writing. Finally, the Supplier’s liability does due to defaults in material or manufacturing not cover normal wear and tear or deterioration.
Need help?
Do you have a question about the nemco UNI-2 and is the answer not in the manual?
Questions and answers