Table of Contents
Advertisement
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
• Disconnect the appliance from the mains
electricity supply before carrying out any work
or maintenance.
• Connection to a good earth wiring system is
essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician.
!
Cut Hazard
Failure to use caution could result in injury.
• Take care: some edges are sharp.
WARNING!
To prevent overheating of the electronic components adequate supply of cool air and
direct unrestricted ventilation to the room is required. A gap of min. 3/16" 4mm height
over the width of the cooktop chassis is required to allow the internal ventilators operating
unrestricted. (Refer to 'Clearances').
IMPORTANT - SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE
The models shown in this installation guide may not be available in all markets and are subject to
change at any time. For current details about model and specification availability in your country,
please go to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
WARNING!
!
WARNING!
SAFETY AND WARNINGS
READ AND SAVE THIS GUIDE
General Use
Read these instructions carefully before installing this product.
z
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
z
Installation must comply with your local building and local electricity regulations.
z
Electrical installation (including electrical grounding) must be done in accordance
z
with the National Electrical Code, ANSI/NFPA70 – latest edition and/or local codes.
In Canada: Electrical installation must be in accordance with the current CSA C22.1
Canadian Electrical Codes Part 1 and/or local codes. Particular attention shall be given
to the relevant requirements regarding ventilation.
This appliance is to be installed and serviced only by Fisher & Paykel trained and
z
supported service technician or qualified person.
The manufacturer accepts no responsibility for the incorrect installation of appliances.
z
Incorrect installation may result in personal injury, damage to property and may
invalidate any warranty or liability claims.
Do not modify this appliance.
z
Do not use or store flammable materials on or near this appliance.
z
Packing elements (eg plastic bags, polystyrene foam, staples, packing straps etc) and
z
tools should not be left around during and after installation, especially if they are within
easy reach of children, as these may cause serious injuries.
Make sure you recycle the packaging material.
z
Before disposing of any appliance, make sure that it can no longer be used and that all
z
hazardous parts are removed or made harmless, so that children playing with the old
appliance cannot harm themselves.
Only genuine replacement parts may be used for servicing the appliance. These are
z
available from your nearest Fisher & Paykel Service Center.
This cooktop must be connected to the mains power supply only by a suitably
z
qualified person.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet
z
storage space located above the surface units should be avoided.
DO NOT use adapters, reducers, or branching devices when connecting the cooktop to
z
the mains power supply to prevent overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
z
temperature will not exceed 165°F (75°C) at any point.
CAUTION : To reduce risk of fire and to properly exhaust air, be sure to duct air outside
z
– Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces,
or garages.
The discharge air is to be directed to the building exterior.
z
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
z
PERSONS, OBSERVE THE FOLLOWING:
z
a) Installation work and electrical wiring must be done by qualified person(s) in
z
accordance with all applicable codes and standards, including fire-rated construction.
b) Ducted fans must always be vented to the outdoors. To eliminate the risk of burns
z
or fire by reaching over heated surface units, cabinet storage space located above the
surface units should be avoided.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet
z
storage space located above the surface units should be avoided. If cabinet storage
is to be provided, the risk can be reduced by installing a non-combustible fixture that
projects horizontally a minimum of 5" (127mm) beyond the bottom of the cabinets.
3
Advertisement
Table of Contents
