Mo Systeme modulbox Manual page 26

They must therefore not be opened or damaged under any circumstances
become!
Minor damage, corrosion or paint residue on the piston rod will cause the
spring to fail (seals will be damaged). The cylinder barrel must not be
damaged or deformed! Basically all lead to changes
by third parties on the product to exclude the warranty.
It is not allowed,...
... to deform, weld, saw, mill, or cut gas springs or their parts
drilling, painting or similar!
... to bend the gas cylinder or the piston rod or both.
... to twist or bend the piston rod against the cylinder.
... to heat or burn gas springs over 100 ° C.
... to attach gas springs differently than at the intended connections. All
fastenings must prevent sideways evasion and rotation
be secured.
... to use gas springs as end stops (exceptions only in accordance with
our "Technical
Regulation "on page 06.015.00).
... to load fully extended gas springs in the pulling direction and fully
retracted gas springs in the compression direction.
... compression gas springs with a tensile load or tension gas springs
with a pressure load
suspend.
... throwing or dropping gas springs or using them as a percussion
instrument.
... to make gas springs accessible to children or people who do not
understand these instructions.
lifespan
• Gas springs must be protected from damage of any kind during
transport and storage
be protected. See all the instructions above.
• Storage temperatures (minus 40 ° C to plus 90 ° C) and operating
temperatures (minus
20 ° C to plus 80 ° C) must be observed.
• It should be stored with the piston rod down.
• The piston rod must not be damaged (e.g. by scratches, welding beads
etc.) or with paint, dirt, acid, glue or aggressive media in
Get in touch.