Table of Contents
Advertisement
Mounting dryer on wall
Determine the position of the
1
dryer on the wall and mark the
bracket position. A minimum
of 50mm is needed between
the top of the dryer and the
ceiling for ease of installation.
If mounting above a washing
machine, allow sufficient
room to open the lid of the
washer. Refer to page 11 for
lid clearances.
Fix the wall hanging brackets to
2
the wall securely, ie into the stud.
If the studs are too far apart, fit a
timber slat to the studs and then
mount the brackets to the slat. If
a slat is used install a second slat
behind the spacers to ensure the
dryer is horizontal. The distance
between the centre of each
bracket is 555mm (A).
To install the hooks onto the
3
dryer, remove one screw from
each side (B), reuse these
screws with two more (each
side) from the kit to fasten the
hooks in place.
Remove plastic plugs from the
4
back of the dryer and screw the
spacers provided in place (C).
With assistance, mount the dryer
5
on the wall brackets.
Fit inverted control panel over
6
the existing panel.
Adjust the display to read
7
correctly on an inverted panel:
For DE7060M and DE5060M
●
●
press and hold the 'Keylock'
and 'Heavy' buttons for three
seconds.
For DE4060M press and hold
●
●
the 'Keylock' and 'Air Dry'
buttons for three seconds.
The dryer will beep to indicate
●
●
you have made a correct
selection, and the display will
change after three seconds.
Repeat the same steps to
●
●
return the panel to the factory
setting.
12
INSTALLATION INSTRUCTIONS
835mm
A
B
C
Advertisement
Table of Contents
