Electrical connection
This appliance must be supplied with a 220 – 240V, 50Hz, sinusoidal, 10A electrical supply.
●
●
Check the power cord for damage, making sure it is not squashed or twisted.
●
●
A damaged power cord must be replaced by a Fisher & Paykel trained and supported
●
●
service technician, in order to avoid a hazard.
The appliance must not be operated until it is repaired, as there is a risk of electric shock.
●
●
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions, which
●
●
may affect how your washer works or may cause flooding.
In multi-storey apartments or any upper floor, the washer should be installed on a floor
●
●
equipped with a drain.
Draining must comply with local by-laws.
●
●
Water supply
IMPORTANT!
Your cold water should not exceed 35°C and your hot water should not exceed 65°C.
Temperatures above these may cause the washer to fault or cause damage to the washer.
If you have an uncontrolled water heating source (eg a wet back or solar heating
●
●
system) you should fit a tempering valve. This will ensure the hot water temperature
remains within safe limits.
Contact your registered plumber to select and install the tempering valve.
●
●
Inlet water static pressure: Max. 1MPa (150psi) Min. 34KPa (5psi)
●
●
Inlet water flow rate at tap: Min. 6 litres/min
●
●
IMPORTANT!
This appliance must be installed in accordance with the installation instructions
●
●
before use.
Provide accessibility to the plug or incorporate a switch in the fixed wiring in
●
●
accordance with the wiring rules to allow disconnection of the appliance from the
supply after installation.
Do not operate this washer if it has been damaged during transport. Contact your
●
●
Fisher & Paykel dealer or Fisher & Paykel trained and supported service technician.
INSTALLATION INSTRUCTIONS
7