Zen Float Tank Assembly Instructions Manual page 8

NOTE: Each valve has a pin in the center that can be manually
pushed down to deflate the wall. If you push down and turn the pin the
airway will stay open for easy deflation. When inflating a panel, check that
the pin is in the proper position to hold air. After each section of the tank
has been inflated make sure you fasten the valve cap. Not doing this might
cause air to leak if the valve pin is pushed down.
5. INSTALL FILTRATION SYSTEM
A. Premade Joint Piece
B. Pump & UV Filter
C. Filter Bag (back of tank)
D. T Joint
E. Elbow Joint
F. Hose Clamp
G. Hose
8