Installation Details - ECO2 Systems SANCO2 GS4-45HPC Owner's Manual

Installation Details

Installation details
This Sanden Eco Hot water Heat Pump System must be installed by licensed personnel in SANCO
2
accordance with local building codes:
 Installing contractor should be licensed by applicable state/province and municipal
authorities to install an Electrical & Plumbing product.
The unit has been designed for heating potable domestic hot water and any other

usage, such as space heating requires a heat exchanger suitable for local codes to
Installation details
be installed on the system to separate potable and non-potable water.
This Sanden Eco Hot water Heat Pump System must be installed by licensed personnel in
The unit is designed to operate when connected to the water supply with a

accordance with local building codes:
maximum operating pressure of 95PSI (655 kPa). To ensure the mains pressure
does not exceed this, first check incoming cold water mains pressure, and then a
 Installing contractor should be licensed by applicable state/province and municipal
pressure regulating device must be connected to the water supply line.
authorities to install an Electrical & Plumbing product.
The unit has been designed for heating potable domestic hot water and any other


usage, such as space heating requires a heat exchanger suitable for local codes to
Installation of a temperature tempering device is MANDATORY to avoid potential
be installed on the system to separate potable and non-potable water.
scalds and burns.
The unit is designed to operate when connected to the water supply with a

The unit must be stored and transported in an upright position. Failure to do so may

maximum operating pressure of 95PSI (655 kPa). To ensure the mains pressure
render the unit faulty. Such failure is not covered under any warranty agreements.
does not exceed this, first check incoming cold water mains pressure, and then a
pressure regulating device must be connected to the water supply line.
Failure to comply with the above conditions will void the warranty.
California Proposition 65 WARNING

This product contains chemicals known to the State of California to cause
Installation of a temperature tempering device is MANDATORY to avoid potential
cancer, birth defects or other reproductive harm. scalds and burns.
The unit must be stored and transported in an upright position. Failure to do so may

render the unit faulty. Such failure is not covered under any warranty agreements.
Failure to comply with the above conditions will void the warranty.
This system delivers hot water exceeding 120
This system delivers hot water exceeding 120
Sanden Heat Pump – Owner's Manual
SANCO Heat Pump – Owner's Manual
Page 7 of 24
2
Page 8 of 28
o F (50 o C).
o F (50 o C).