Advertisement
HOW TO USE THE BATTERY CHARGER
1.
Once the output clamps have been connected to the battery, connect the power cord to the
mains socket, making sure that the voltage corresponds to the rated voltage of the charger.
With the charger in "stand-by" mode, set the appropriate charge parameters using the mode
2.
button to select the correct voltage.
For 12V batteries the following charging parameters can be selected via the "Function" button:
5A
12.5A
25A
5A
12.5A
25A
5A
12.5A
25A
The RECONDITION mode is for WET and AGM batteries that have long been inactive and have an
acid stratification. Caution: due to the high voltage that is reached during this charging cycle,
4A-8A-16A
recovery must be carried out with battery removed from the vehicle. A battery recovery connected
AGM
to the vehicle could cause damage to the on-board electronics. (Only in 12V mode)
After selecting the appropriate 12volt function the charging process starts automatically after 5 seconds.
For charging 12V 5Ah to 100Ah batteries
Maintenance for 12V 5Ah to 150Ah batteries
Suitable for charging WET and Gel batteries
For charging 12V 70Ah to 250Ah batteries
Maintenance for 12V 70Ah to 360Ah batteries
Suitable for charging WET and Gel batteries
For charging 12V 150Ah to 550Ah batteries
Maintenance for 12V 150ah to 800Ah batteries
Suitable for charging WET and Gel batteries
For charging 12V 5Ah to 100Ah batteries
Maintenance for 12V 5Ah to 150Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET batteries
with temperatures below 5C°
For charging 12V 70Ah to 250Ah batteries
Maintenance for 12V 70Ah to 360Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET batteries
with temperatures below 5C°
For charging 12V 150Ah to 550Ah batteries
Maintenance for 12V 150ah to 800Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET batteries
with temperatures below 5C°
For charging 12V 5Ah to 100Ah batteries
Maintenance for 12V 5Ah to 150Ah batteries
Suitable for charging lithium batteries: LiFePO4 (do not charge other types of lithium
batteries)
For charging 12V 70Ah to 250Ah batteries
Maintenance for 12V 70Ah to 360Ah batteries
Suitable for charging lithium batteries: LiFePO4 (do not charge other types of lithium
batteries)
For charging 12V 150Ah to 550Ah batteries
Maintenance for 12V 150ah to 800Ah batteries
Suitable for charging lithium batteries: LiFePO4 (do not charge other types of lithium
batteries)
Lithium batteries are equipped with a BMS that in some cases can prevent the start of
the charging cycle; in this scenario to activate the charge process Press and hold the
"Function" button for 5 seconds, after setting the charger in lithium mode.
Advertisement
