Courion iLEARN System Manual page 26

iLEARN Door Control Menu Screens
1.4.3 Gate Digital Inputs
02 - Encoder Preset Feedback
07 - Car Station Reset Button
08 - Rear Gate Selection
1.4.4 Gate Digital Outputs
02 - Encoder Preset Command
04 - Gate Not Open
05 - Retiring Cam
06 - Light Curtain Test
07 - Strobe Light
08 - Buzzer
1.4.5 Gate Open Position - This is the FULL OPEN encoder reading for the Gate Panel after
the iSYSTEM and gone through its "learn" sequence.
1.4.6 Gate Status Bits #1
01 - Close Button - '1' when COP Close Button is pushed.
02 - Open Button - '1' when COP Open Button is pushed.
03 - Light Curtain #2 Fault - '1' when Light Curtain #2 reports a fault.
04 - Light Curtain #1 Fault - '1' when Light Curtain #1 reports a fault.
05 - General Fault - '1' when iDRIVE.G is reporting a general fault.
06 - Motor Fault - '1' when iDRIVE.G is reporting a motor fault.
07 - Light Curtain #2 Reverse - '1' when Light Curtain #2 causes a reversal.
08 - Light Curtain #1 Reverse - '1' when Light Curtain #1 causes a reversal.
09 - Reversing Edge - '1' when Reversing Edge causes a reversal.
10 - Reversing Event Latch - '1' when any reversing event is detected.
11 - Gate actively Closing (or holding close) - '1' when Gate is Closing.
12 - Gate actively Opening - '1' when Gate is Opening
13 - Almost Closed - '1' when Gate is within 12" of Full Close.
14 - Almost Open - '1' when Gate is within 12" of Full Open.
15 - Fully Closed - '1' when Gate is within 1" of Full Close.
16 - Fully Open - '1' when Gate is within 1" of Full Open.
26
iLEARN System Manual
(continued)
ver.071217-2.10