Courion iLEARN System Manual page 15

iLEARN Door Control Description
SELECT/MENU Knob - The Select/Menu Knob is used to scroll through (turn) and select (push)
Menu Items on the iLEARN Display. After making a change in the Menu, the change is saved to
the iLEARN Control when you push the SELECT/MENU Knob.
IMPORTANT - Changes made on the iLEARN Door Control to the iDRIVE Parameters (Section 4
- Edit Parameters) will not be saved to the hoistway iDRIVEs until the System is restarted.
See the iLEARN Door Control Menu Screens Section of this Manual for further information.
USB Port - The USB Port is used to update the iLEARN and iDRIVE programs. It can also be
used to download the Event History captured by the iLEARN Door Control to a USB device.
SCADA CAN Port - This port allows the iLEARN Door Control to connect directly to an Elevator
Controller's CAN port rather than using the AC inputs and relay outputs described below.
iDRIVE Network LEDs (RX & TX) - These LEDs indicate the receipt (RX/Red) and transmission
(TX/Green) of information over the CANbus network between the iLEARN Door Control and the
iDRIVE units on the network. During normal operation, these LEDs should be rapidly flashing. If
both lights are not rapidly flashing, there is a communication error on the CANbus network that
needs to be resolved - See the Troubleshooting and Error Message Section of this
Manual.
STATUS LED - This LED indicates the overall STATUS of your COURION System.
1 Flash Per Second - System is Ready with normal operation
2 Flashes Per Second - Active iDRIVE Fault on the CANbus Network
3 Flashes Per Second - Memory Failure
4 Flashes Per Second - CAN Controller Failure
If the STATUS LED is something other than 1 Flash Per Second - See the Troubleshooting and
Error Message Section of this Manual.
+5V & +24V LEDS - These LEDs indicate that the iLEARN Control has the necessary power for
the CANbus Network and Digital Inputs. These LEDs should be constantly ON.
15
iLEARN System Manual
ver.071217-2.10