ADJUSTING THE DEPTH
Applicable for 30" Vacuum seal drawer only. The depth of the front panel of the drawer can be
adjusted to align with the surrounding cabinetry.
1
2
18
Open the drawer fully.
Using a hex key, turn the adjustment
screw to move the front panel forward.
Turn clockwise to move backwards or
counterclockwise to move forwards.
The depth is adjustable within
3/16" (4mm).
ADJUSTING THE HEIGHT
The front panel of the drawer can be adjusted vertically to align with the surrounding
cabinetry.
1
2
3
Open the drawer fully, and slightly
loosen the two screws.
Adjust to the required height and then
re-tighten the screws. The height is
adjustable within 5mm.
Close the drawer and check the
alignment. Adjust again if necessary.