Troubleshooting - Electrum Sabercrafts Smart Saber Aegis Operation Manual

Troubleshooting

Towards Blade
Hard Reset
(Bottom Button)
Once Switch LEDs start flashing, hold the Correct
button until they blink slowly (3 times for Soft Reset,
6 for Hard Reset), as shown above.
Resetting the Saber
You may encounter a scenario were you want to restore your factory settings, or refresh
some aspects of the saber, as in the case of loading sound fonts. The Saber has Soft Reset
function, which will reset some values to factory settings, while leaving your user profiles
and color banks intact, and a Hard Reset function which will restore the Saber to factory
settings, and reload all sound banks. Both resets will recalibrate the Touch Switch.
All custom settings, including custom sound banks, motions, colors, and profiles will
be erased when performing the Hard Reset process.
User profiles are stored in the app memory by Saber Name. Be sure to rename your
saber after a Soft Reset (if you had before) to regain them on the app.
To reset the Saber, toggle the Deep Sleep Switch.
Once all the LEDs on the switch begin flashing, hold the corresponding button (see above)
until the LEDs blink together; 3 times for a Soft Reset, 6 for a Hard Reset. Release the button
when they start to blink in this sequence. The saber will boot into color bank 1 and default to
the first sound font on your SD card.
Find more information at ElectrumSabers.com/Resources
Towards Blade
Soft Reset
(Middle Button)
Deep Sleep
Switch
8