Hussmann CID Technical Data Sheet

7
These merchandisers are manufactured to meet ANSI/National Sanitation
Foundation Standard #7 requirements.
We reserve the right to change or revise specifications and
product design in connection with any feature of our
products. Such changes do not entitle the buyer to
corresponding changes, improvements, additions or
replacements for equipment previously sold or shipped.
Specialty Products
CID
Engineering
CROSS SECTION
CUL Listed
UL Sanitation
Discharge Air (F)
Evaporator (F)
Note: Not recommended to control temp by regulating
coil temp allow t-stat to cycle and control temp.
Btu/hr/ft*
Parallel
Conventional
Btu/hr/ft*
Parallel
Conventional
*For all refrigeration equipment other than Hussmann,
use conventional Btu values.
Frequency Hrs
OFFTIME
Temp Term °F
Failsafe Minutes
ELECTRIC or GAS
Merchandiser Drip Pipe (in.)
Merchandiser Liquid Line (in.)
Merchandiser Suction Line (in.)
Estimated Charge (lb)***
*Dependent on case length and refrigerant type.
*** This is an average for all refrigerants types. Actual
refrigerant charge may vary by approximately half a
pound.
1 of 7
CID
Technical Data Sheet

REFRIGERATION DATA

Note: This data is based on store temperature and
humidity that does not exceed 75F and 55% R.H.
26
15
Center
1950
2243
Crown
3000
3450

DEFROST DATA

Not Recommended

PHYSICAL DATA

4ft 1.2
5ft 1.5
6ft 1.8

GLYCOL REQUIREMENTS

GPM PSI
NA NA
NA NA
NA NA
Rev A
8
54
46
1 ½*
3/8*
5/8*