Restoring The Factory Default Settings - Cisco Network Switch Cabling User Manual

Restoring the factory default settings

At this prompt...
sw01>
sw01#
At this prompt...
sw01#
Delete filename [vlan.dat]?
Delete flash:vlan.dat? [confirm]
C A R
ASSATT CTIVE ESPONSE
4. Plug in the Cisco switches in a stack.
5. Many boot-up and self-test messages will scroll on the console monitor. When the
process is completed, use the following table to determine your next step:
If the following displays at the
prompt...
Continue with configuration
dialog? [yes/no]:
Press RETURN to get started!
To reset the switches in a switch stack to the factory defaults, you must delete the startup
configuration and virtual local area network (VLAN) database files. Execute the following
privileged command sequence to restore the Cisco Catalyst 3750 Series switch configuration
to the original factory setting:
1. Delete the startup configuration and configuration files, as follows:
Erasing the nvram filesystem will remove all configuration
files! Continue? [confirm]y[OK]
Erase of nvram: complete
00:06:43: %SYS-7-NV_BLOCK_INIT: Initalized the geometry of
nvram.
2. Delete the VLAN database, as follows:
C N
ONTROL ODE AND
Then...
The switch stack is in the factory default state; go to
step 1 in
configuring the switch.
The switch stack has already been configured and the
switch stack must be restored to the factory settings;
go to step 1 in
page 22.
Enter...
enable
write erase
Enter...
delete flash:vlan.dat
Select Enter
y
N S C
ETWORK WITCH ABLING
Setting switch options
on page 24 to continue
Restoring the factory default settings
Notes
Displays the following output:
Notes
E
XAMPLE
on
22