Additional Features; Back Panel; Returning The Device To The Factory Default Settings - Cisco 200 Series Quick Start Manual

PoE (if present)—(Amber) Located on the right of the port. Lights steady to
indicate that power is being supplied to a device attached to the
corresponding port.
100M LED (if present)—(Green) Located on the right of the port. Lights
steady when another device is connected to the port, is powered on, and a
100 Mbps link is established between the devices. When the LED is off, the
connection speed is under 100 Mbps or nothing is cabled to the port.
Gigabit LED (if present)—(Green) Located on the right of the port. Lights
steady when another device is connected to the port, is powered on, and a
1000 Mbps link is established between the devices. When the LED is off,
the connection speed is under 1000 Mbps or nothing is cabled to the port.
SFP (if present)—(Green) Located on the right of a GE port. Lights steady
when a connection is made through the shared port. Flashes when the port
is passing traffic.

Additional Features

The switch might also have a reset button. The switch can be reset by
inserting a pin or paper clip into the reset opening. See
Device to the Factory Default Settings

Back Panel

The power port is located on the back panel of the smart switch.
Returning the Device to the Factory
5
Default Settings
To use the Reset button to reboot or reset the smart switch, do the
following:
• To reboot the smart switch, press the Reset button for less than 10
seconds.
• To restore the smart switch configuration to the factory default settings:
1. Disconnect the smart switch from the network or disable all DHCP
servers on your network.
2. With the power on, press and hold the Reset button for more than
10 seconds.
10
Returning the
for details.
Cisco 200 Series Smart Switches