Related Manuals for ZANE ARTS PS-011
Summary of Contents for ZANE ARTS PS-011
- Page 1 O w ne rs M anu al E N G / V e r 1 . 0 0 S M A L L S I Z E O N E P O L E S H E L T E R P S - 0 1 1 / G I G I - 1...
- Page 2 ■ Items Included Please check the contents of the set before fully opening the tent. If you find something missing, please contact the store where you purchased it or us directly. Center pole x1 Extension pole x2 Tent body x1 V-Peg rope rope Peg &...
- Page 3 Apply seam sealant There is a place where seam tape cannot be attached to the joint at the tip of the indoor ceiling of PS-011 / GIGI-1. In the unlikely event of leakage, you may choose to apply a...
- Page 4 Wrinkles caused by folding are noticeable Commonly used chemically treated fibers used in tents, shelters and tarps are prone to creases. In particular, the fabric in this product has noticeable wrinkles due to the color, thickness, and surface processing of fabric. Please note that it does not affect performance in any way.
- Page 5 Thoroughly dry and store If tent is stored while wet, the polyurethane coating on the back of the fabric will react with the moisture and may decompose or peel off, causing the seam tape to come off and diminish its waterproofness. After using, dry thoroughly and store away from hot or humid places.
- Page 6 ■ Precautions for setup and use Be sure to read and understand the following contents before use to prevent harm to the user and others, and damage to property. Indicates content that may result in death or serious injury. Danger ●Fire is not allowed in tents, shelters, and tarps. It is extremely dangerous as there is a risk of fire, oxygen deficiency, carbon monoxide poisoning, etc.
- Page 7 Indicates content that may cause injuries or property damage. Warning ●Not for permanent use. If this product is set up permanently, it will deteriorate and be damaged in a short period of time due to the effects of ultraviolet rays and other elements. ●Set up on a flat surface with good drainage.
- Page 8 ●When setting up, be prepared for wind gusts and be sure that the main body and frame don’t fly away by keeping your hands on the frame and main body while working. ●When extending poles or frames, make sure each section is inserted securely.
- Page 9 ■ Precautions for teardown and after use care Be sure to read and understand the following contents before use to prevent harm to the user and others, and damage to property. Indicates content that may cause minor injuries or property damage. Warning ●When taking down the product, be sure to have two or more people.
- Page 10 ●After use, clean the fabric and allow it to dry thoroughly before storing. If it is stored with dirt or moisture uncleaned, it may cause colors to transfer or mold odors to form, and may cause the seam tape to come off and diminish its waterproofness.
- Page 11 ■ Setup procedures Set up according to the numerical order. 【Prepare in Advance】 *Make a loop on pegs with commercially available rope φ2mm ・ 20cm Assembling the base *Close all zippers Drive the pegs into the ground to hold auxiliary rope for Assembling strong wind and rolling of the ends...
-
Page 12: Assembling The Base
Assembling the base A ： Make a rectangle by driving V-Pegs into the ground through the rubber loops at the four corners where there is building tape (webbing). B ： Insert the center pole from the side and stand it up create the main structure. - Page 13 Assembling the ends A ： Insert the upper part (long end) of the extension pole into the grommet. B： Insert the lower part (short end) of the extension pole into the grommet. C ： Drive the V-Pegs into the ground D ： Attach 4 m rope to the extension pole E：...
- Page 14 Drive the pegs into the ground to hold auxiliary rope for strong wind and rolling of panel Rope setting A ： Attach 3 m ropes Mounting (auxiliary rope for strong winds) loop (4 places in total front and back). B ： Drive tent pegs into the ground (4 places in total, front and back).
- Page 15 Pop-up Door Panel *To build the open entrance, 2 extra poles and 2 extra pegs (sold separately) are required. A ： Insert the tip of the pole into the grommet. B ： Drive pegs and use 3m ropes. (3 locations) Ring Ring T0-052 / Upright Pole 150 (sold separately)
- Page 16 ZANE ARTS , Inc. 716 8-13 Sh im auc hi, Mat s umo t o , N ag a n o 390 - 0851 inf o@zane art s .c om...