Table of Contents
Advertisement
Connecting an AC-Input Power Supply
If your chassis is equipped with AC-input power supplies, you need to run the AC power cord from the
source AC to the AC-in connector on the AC-input power supply.
To attach the AC power cord between source AC and the AC-input power supply (see
these steps:
Verify that the system (NEBS) ground connection has been installed.
Step 1
Remove the AC power cord from its packaging.
Step 2
Verify that the AC power cord plug is the correct one for your installation site. There are nine different
Step 3
AC power cords available. For AC power cord details, see the Cisco ME 6500 Series Ethernet Switches
Installation Guide.
Verify that the power supply is completely seated in the chassis and that the captive installation screws
Step 4
are tight.
Step 5
Verify that the power supply power on/off switch is off.
Step 6
Connect the C15 appliance plug to the AC-in receptacle on the power supply.
Connect the power cord plug to the source AC outlet.
Step 7
Figure 9
Captive
installation screw
IEC 60320 C15
connector
78-17360-02
Installing an AC-Input Power Supply
Power switch
o
+
-
o
OU TP UT
INP UT
OK
FA N
+
OK
OK
-
OU TP UT
INP UT
OK
FA N
OK
OK
Captive
installation screw
o
+
o
-
+
OU TP UT
INP UT
OK
FA N
-
OK
OK
OU TP UT
INP UT
OK
FA N
OK
OK
Cisco ME 6500 Series Ethernet Switch Installation Note
Connecting the Power Supplies
Figure
9), follow
19
Advertisement
Table of Contents
