Table of Contents
Advertisement
DPX-530
7. Removal of the terminal ASS'Y
and TERMINAL PCB ASS'Y
1. Remove the top case unit and terminal cover ASS'Y
following "1. Removal of the top case unit and terminal
cover ASS'Y."
2. Remove the MAIN PCB ASS'Y following "2. Removal
of the MAIN PCB ASS'Y."
3. Remove the three screws (a) as shown in Fig. 2-5.
4. Remove the two screws (b) as shown in Fig. 2-5.
5. Remove the terminal ASS'Y as shown in Fig. 2-5.
6. Disconnect the connector (TD) on the TERMINAL PCB
ASS'Y as shown in Fig. 2-6.
7. Remove the two screws (a) as shown in Fig. 2-6.
8. Remove the two screws (b) as shown in Fig. 2-6.
9. Remove the four screws (c) as shown in Fig. 2-6.
10. Remove the four screws (d) as shown in Fig. 2-6.
11. Remove the terminal holder,pin jack shield and remo
barrier as shown in Fig. 2-6.
12. Remove the two screws (e) as shown in Fig. 2-6.
13. Remove the terminal L earth and terminal R earth as
shown in Fig. 2-6.
16
a x3
b x2
Fig. 2-5
TERMINAL PCB ASS'Y
Terminal L earth
TD
e
x2
a x2
b x2
d x4
c
x4
Fig. 2-6
Terminal ASS'Y
Terminal R earth
Pin jack shield
Remo barrier
Terminal holder
Advertisement
Table of Contents
