Table of Contents
Advertisement
C2-LGE
Impact
Dairy / Delicatessen
Precut & Packaged Produce
CANOPY AND SHELF LAMP BALLAST
The ballast for the canopy and shelf lamps is located
behind the canopy on the left-hand end (when facing
case) of the merchandiser.
To access the ballast:
1. Remove screws at bottom edge of canopy and rear
of top panel.
2. Remove the one piece canopy top panel by moving
panel forward slightly to clear flange in front then
lifting up.
3. Service or replace ballasts as required.
4. Reassemble items as they were originally installed.
NOTE: Rail lamp ballast is located behind the lower
front panel.
CANOPY ANTI-SWEAT HEATER
The canopy anti-sweat heater location is shown below.
Connections are in the Electrical wireway.
Foil-covered
Anti-sweat
Heater
8 of 8
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Canopy
Electrical
Wireway
Screws
Ballast
Canopy
Anti-Sweat Heater Wires
with Purple Markers
C2-LGE
Screws
Technical Data Sheet
Advertisement
Table of Contents
