Yamaha SW60XG Authorized Product Manual page 3

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements.
Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded
cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Failure to follow instructions
could void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for
Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of
this product in a residential environment will not result in harmful interference with other electronic devices. This equip-
ment generates/uses radio frequencies and, if not installed and used according to the instructions found in the user's
manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations
does not guarantee that interference will not occur in all installations. If this product is found to be the source of interfer-
ence, which can be determined by turning the unit "OFF" and "ON", please try to eliminate the problem by using one of
the following measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna.
If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the your local retailer authorized to dis-
tribute this type of product
If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division,
6600 Orangethorpe Ave, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
PRECAUTIONS
The SW60XG contains no user-serviceable parts. Do not
touch the inside area of the circuit board or tamper with the
electronic circuitry in any way. Doing so may result in elec-
trical shock or damage to the sound card.
When holding the sound card, do not touch the inside area
of the circuit board or apply excessive pressure to the
card. Be sure to protect the card from contact with water or
other liquids.
Before installing the SW60XG in the computer, unplug the-
computer power connector.
Immediately before touching the sound card, be sure to
touch a metal surface to discharge any Static electricity
from your body.
Before connecting the computer to other devices, turn off
the power switches of all devices.
Do not expose the SW60XG to direct sunlight, excessive
humidity, high temperatures, excessive dust, strong vibra-
tions, or mechanical shock.
The SW60XG contains digital circuitry and may cause
interference if placed too close to radio or television
receivers.
It is possible that computer malfunctions or operator
actions may destroy data that was created with the includ-
ed application software. We recommend that you back up
all important data onto floppy disks or other storage media.
Yamaha is not responsible for data loss through computer
malfunctions or operator actions.
Yamaha cannot be held responsible for damage caused by
improper care and use of the SW60XG and software.
NOTICE: The screen displays as illustrated in this owner's manual are for instructional purposes, and may appear somewhat different from the screens which appear
on your computer. Future upgrades of application and system software and any changes in specifications and functions will be announced separately.
FCC ID: A6RSW60
FCC INFORMATION (U.S.A)
SPECIAL NOTICES
The software and this owner's manual are the exclusive
copyrights of Yamaha Corporation.
Copying of the software or reproduction of this manual in
whole or in part by any means is expressly forbidden with-
out the written consent of the manufacturer.
Use of the software and this manual is governed by the
license agreement which the purchaser fully agrees to
upon breaking the seal of the software packaging. (Please
read carefully the Software Licensing Agreement at the
end of this manual before installing the application.)
Yamaha makes no representations or warranties with
regard to the use of the software and documentation and
cannot be held responsible for the results of the use of this
manual and the software.
Windows and MS-DOS are the registered trademarks of
®
Microsoft Corporation.
IBM PC/AT TM is a trademark of IBM
The company names and product names in this Owner's
Manual are the trademarks or registered trademarks of
their respective companies.
®
Corporation.