Summary of Contents for Bombas Omega 2C Series
- Page 1 BOMBAS OMEGA INSTRUCTIONS, INSTALLATION, STARTING UP AND MAINTENANCE SUBMERSIBLE PUMPS...
-
Page 2: Table Of Contents
We advise to read carefully this manual, paying attention to the recommendations indicated, which fulfill the directives of the CEE about machines. The wrong utilization or manipulation of the product supplied by Bombas Omega invalidates the responsibility of our company for the possible damages caused, either material or personal damages. - Page 3 3.3 DISCHARGE PIPES They must be installed according to the following drawing: The discharge pipe must have a check valve installed in order to absorb the water hammer that could be produ- ced and to avoid the return of the suction fluid, which can cause serious problems. From the drawing for permanent installation of the submersible pump, the anchoring base of the pumps will be If there are high points in the discharge pipe, it is necessary to install in those ones a few air valves (air purgers), placed on a foundation of concrete of suitable dimensions.
-
Page 4: Starting Up
In standard execution the motors of the Bombas Omega pumps up to 7,5 HP are prepared for direct start (230V or 400V). For powers bigger than 7,5HP the connections are prepared for delta/star or direct start. - Page 5 THERMICAL PROTECTION SCHEME 4.5 PROTECTION CABLES All the Bombas Omega pumps bigger than 7,5HP have always thermal and antihumidity protections. To connect these protections to the control panel, the pumps have an auxiliary cable for alarms (4 x 2,5), which is connected to the control panel.
-
Page 6: Maintenance
BEARINGS AND THEIR GREASING: DAMAGED The pumps of Bombas Omega up to 12,5HP 1000 rpm, 25HP 1500 rpm and 30HP 3000 rpm have bearings greased for life. The Bombas Omega submersible pumps are designed to work with loaded fluids, polluted or aggressive fluids, The pumps with bigger powers have internal greasing, so it is convenient to grease them each 2 working which can be harmful for the health, so proceed carefully. -
Page 7: Storage
SECTIONS AND SPARE PARTS MARK GREASE LS-EP2 SERIE 2A SERIES 2C/4C (1,5-4HP 3000rpm/1,5-2HP 1500rpm) CEPSA LITION 2EP ESSO BEACON2EP MOBIL LERITAL 2 SHELL ALVANIA STORAGE When it is necessary to store a pump, proceed as per the following instructions: • If the pump has been used, proceed to its internal and external cleanliness with suitable products. - Page 8 COMPLETE LIST SPARE PARTS REF. CONCEPT CONCEPT CONCEPT ROTOR ROTOR ROTOR SHAFT ARBRE SERIES 2C/4C/6C (5,5-25HP 3000rpm/ SERIE OG (3-60HP 1500rpm/10-50HP 1000rpm) IMPULSOR IMPELLER ROUE 3-60HP 1500rpm/10-50HP 1000rpm) CUERPO DE BOMBA PUMP CASING CORPS DE POMPE TAPA CUERPO DE BOMBA PUMP CASING CAP COUVERCLE CORPS POMPE CAMARA ACEITE...
- Page 9 POLIG. IND. “EL CAMPILLO” PAB. 10B 48500 - ABANTO (SPAIN) Tel.: 34-94-6363510 Fax: 34-94-6363501 bombas01@bombasomega.com...