Advertisement
Step 4
TRANSDUCER ASSEMBLY- Insert the transducer assembly into the metal bracket from the bottom.
Push up until the holes in the plastic pivot align with the uppermost holes in the bracket. Slide the O-
ring on to the headed pin and insert it through the two parts. Assemble by screwing the ¼"x3/8" allen
head screw into the end of the pin and tighten. (See Figure G)
Step 5
ANGLE ALLIGHMENT- Set the transducer angle so that it is parallel with the bottom of the boat hull.
Once proper alignment is achieved, tighten the two allen head screws using the 5/32" allen wrench
Advertisement
