Advertisement
8. Lay out the sides and ends around the bottom. The bottom should have the magnets facing
up. The ends and sides are keyed to the bottom, so they will only fit one side correctly.
9. Dry fit the sides and ends with the bottom to ensure a tight a proper fit with each piece. The
corners should not have any gaps. Do not move to the next step until you are satisfied with
the fitting of the parts.
10. Start with one of the sides and the bottom.
Place CA on the inside edge of the bottom.
Place the side on the bottom, holding the
two parts perpendicular for about 8
seconds.
11. Next dry fit one of the ends to make sure the
corner with the side still fits with no gaps.
12. Apply the CA to the bottom and the edge
(where is joins with the previously glued side)
of the end piece and place into position.
4
Advertisement
