Advertisement
Assembly
1. Please note that the transformer design modeled in this kit has many small, fine features, which
are delicate.
get damaged.
2. Use medium viscosity CA glue only. No other glue will hold the parts together. Only a small
amount of glue is necessary. Place a small amount of glue on the part and spread the CA
with a toothpick so all the joint surface is covered. Error on the side of less glue, as you do not
want glue to ooze out the joints.
3. Test fit the brackets on the one end piece as shown below. They should fit snugly, but use a
small file if necessary to remove material from the tabs on the end piece so the brackets fit
flush. Use a small amount of medium CA to glue these parts in place.
4. Test fit the 12 detail parts on the roof as shown below. Use a small amount of medium CA to
glue these parts in place. A toothpick will be handy to apply glue to the smaller parts.
Hold the panels by the edge to minimize the chance that any of those features
2
Advertisement
