To Un-Synchronize Two Zedbed Adjustable Bed Systems; Electrical Specifications - Zedbed Z-PEDIC User Manual And Maintenance

TO UN-SYNCHRONIZE TWO ZEDBED
ADJUSTABLE BED SYSTEMS
1. Disconnect both systems from the wall outlets.
2. Disconnect the 2 cables that are connected to both units.
3. Flip the units so that you may access the electrical components.
4. You need to connect the remote control receiver cable into the motor of
the unit where the remote control receiver was not connected to the motor
but you must first disconnect the cable that is plugged in, this will no longer
be used.
5. Connect one of the two beds to the wall outlet. You will hear a signal (beeping).
6. Take one of the remotes and hold the two top buttons (the first button of
each column) until the beeping is continuous and then stops. The remote
will now work for this Zedbed system.
7. Redo step #5 and #6 again for the 2nd Zedbed system.

ELECTRICAL SPECIFICATIONS

IN : AC 100V/110V – 50/60Hz – 1.6A
OUT : DC 29V – 2A
In case of a power surge, the transformer is equipped with a device that will stop
the bed from functioning. You will need to let the unit rest for a few minutes
before it begins to function again.
6