Installation Guide - Zedbed Z-PEDIC User Manual And Maintenance

INSTALLATION GUIDE

HOW TO INSTALL THE BED LEGS
• Flip over the entire Zedbed adjustable bed system, you should be able to
see the motor when you do this. Once you have flipped the bed around
please remove from their packaging the legs, the power cable, the remote
and the foot end rail (depending on your model). You will want to make
sure everything is well connected.
• For models with metal legs you will need to select the desired height. You
will have a choice of 4 height options: for 1.5" you will only need to use
part A. For 2.5" you will need to thread part A into part B. For 6.5" you
will need to thread part A with part C. For 8.5" you will need to thread
together part A, part B and part C. ATTENTION part A must ALWAYS be
used.
• You will have 4 legs in total that will need to be screwed into the Zedbed
system making sure that there is no visible gap between the metal base
and the legs. No tools are required for assembly.
• After the instructions above have been done you will need to flip the
Zedbed system so that it is resting on the legs (back to its original
position). Now it is ready to be paired with the mattress.
3
A B C