Removing Power Supply Modules - Cisco SFS InfiniBand Server Switch SFS 7000P Hardware Installation Manual

Removing Power Supply Modules

Removing Power Supply Modules
Do not remove the power supply module without first removing the screws. Use a number 1 Phillips or
Caution
a slotted screwdriver.
To remove a power supply module, follow these steps:
Step 1 Make sure you have a number 1 Phillips or a slotted screwdriver to disengage the fasteners.
Step 2 Ground yourself appropriately.
Caution Never place your hand inside an empty card or module bay or anywhere inside the
Cisco SFS 7000P and SFS 7000D Server Switches.
Locate the power supply module that you want to remove.
Step 3
If you have two power supply modules installed, you can remove one of them without removing power
from the switch.
Unscrew the fasteners that hold the power supply module in place. (See
Step 4
Figure 4-4
Pull the unit from the bay.
Step 5
Install the filler panel in place of the power supply module, or install a new power supply module. If you
Step 6
are installing a new power supply module, see the
page
Caution Never operate the device without a filler panel or power supply module in place because the device might
overheat.
Cisco SFS 7000P and SFS 7000D InfiniBand Server Switches Hardware Installation Guide
4-4
Removing the Screws from the Power Supply of the Switch
4-2.
Chapter 4 Installing Field Replaceable Units
Figure
"Installing a Power Supply Module" section on
4-4.)
OL-10853-01