Sareer Balatin Daydream Tufted Daybed Assembly Instructions

mins

Approximate

Assembly Time

Two persons are

recommended to

assemble this product

Daydream Tufted Daybed

BEFORE STARTING...

Read the assembly instructions carefully before beginning assembly.

Check and ensure that you have all parts and fittings for complete assembly.

Choose a clean, level, spacious assembly area. Hard surfaces may damage the product.

The packaging and contents can be a choking hazard, therefore keep out of reach

of small chidren at all times.

Do not over tighten the bolts as this may damage the thread.

Table of Contents

Do you have a question about the Balatin Daydream Tufted Daybed and is the answer not in the manual?

Page 1 mins Approximate Assembly Time Two persons are recommended to assemble this product Daydream Tufted Daybed BEFORE STARTING... Read the assembly instructions carefully before beginning assembly. Check and ensure that you have all parts and fittings for complete assembly. Choose a clean, level, spacious assembly area. Hard surfaces may damage the product. The packaging and contents can be a choking hazard, therefore keep out of reach of small chidren at all times.
Page 2 HARDWARE M8 x 25mm M8 x 40mm Threaded rod Hex Nut x 4pcs x 2pcs x 6pcs x 8pcs Allen Key Washer Spanner x 1pc x 10pcs x 1pc PART...
Page 3 Screw in the wooden legs and threaded rods to side panels. Attach the siderail and back panel to the side panels. Back View...
Page 4 Secure the back panel as shown in diagram. Attach across rail to the base. Align the pins on the Holders to the holes along the siderail and back panel. Gently tap them into the holes using hand palm.
Page 5 Retightening of all fixing periodically is recommended. When moving your fully assembled bed you must first remove the mattress and lift the frame into position, take care when lifting and always have two people handling the bed. PLEASE DO NOT DRAG THE BED as this will cause damage to the rail.