Cisco Catalyst 4900M Installation Manual page 58

Configurable Modules
Figure 3-11
1
Captive screw
Carefully slide the switching module into the slot until both ejector levers engage the chassis sides
Step 7
equally and the module is seated in the backplane.
Use a screwdriver to tighten the captive installation screws on each end of the switching module
Step 8
faceplate.
To check the status of the module, perform the following steps:
Step 1 Ensure that the STATUS LED is green (module operational).
When the switch is online, enter the show module command. Verify that the system acknowledges the
Step 2
new module and that the module's status is listed as good in the command output.
If the module is not operational, reseat it. If the module is still not operational, contact your customer
Step 3
service representative.
Cisco Catalyst 4900M Switch Installation Guide
3-18
Installing the Switching Module in the Chassis
1
Chapter 3
1
Installing the Switch
78-18350-02