Vascular Patient Restraint Strap; Paper Roll Holder - OAKWORKS MEDICAL PRODUCTS PG Series User Manual

Table of Contents

Advertisement

DIRECTIONS FOR USE
T O M O V E T H E F O O T B O A R D T O T H E 4" (10 cm.) P O S I T I O N
Grasp the rod at 90º
bend and push into
the table to unlock.
Check locking by moving footboard left and right.
V A S C U L A R P A T I E N T R E S T R A I N I N G S T R A P U S E
CAUTION
VASCULAR FLAT TOP TABLES
Install the strap under the rail to the top.
P A P E R R O L L H O L D E R U S E
To load the paper, pull down on the 2
paper holder support arms located on
the under side of the Fowler section and
rotate to the 90º position.
27
With your second hand,
grasp the foot board &
rotate 180º to the down
position.
The Vascular Patient Restraining Strap must be used during all procedures to prevent from falling off
the table.
Insert the rod through the paper roll and
place the rod into the holes in the sup-
port arms.
Grasp the rod at 90º
bend and pull to the 4"
(10 cm.) position.
VASCULAR WITH FOWLER TABLES
Install the strap under the Fowler section & above
all rails.
With your second hand,
grasp the foot board
and rotate 180º to the
up position
Pull paper and thread through the paper cutter
across the upholstered top to keep in place and to
cut used paper after a procedure.
Note: The paper "cutter" strap is attached with hook and
loop fastener. This allows strap tension adjustment if nec-
essary.
Grasp the rod at 90º
bend and pull away
from the table to lock
in position.

Advertisement

Table of Contents
loading

Table of Contents