Bosch IXO Original Instructions Manual page 30

30 | English
During the charging process, the handle of the power tool will become
warm. This is normal.
If you are not planning to use the power tool again soon, disconnect the
charger from the mains.
The power tool cannot be used during the charging process. It is not defect-
ive if it does not work during the charging process.
Protect the charger against moisture.
u
Changing the tool (see figure A)
Insert the screwdriver bit (1) directly into the tool holder (2).
Off-set Angle Adapter/Angle Screw Adapter/Torque Setting
Adapter (see figures B–E)
You can drive in screws close to edges using the off-set angle adapter (13).
The angle screw adapter (14) allows you to drive in screws in hard-to-reach
areas.
The torque presetting ring (16) on the torque setting adapter (15) can be
used to pre-select the required torque in 10 stages. When the correct set-
ting is used, the application tool will be stopped when the screw is driven
flush into the material or once the set torque has been reached.
Assembly (see figures B–C)
To fit the adapters, pull off the worklight cover (7) towards you. Then the ad-
apters can be attached. It is possible to fit an adapter offset by 45°.
Removal (see figures D–E)
To remove an adapter, turn the unlocking ring (23) in rotational direction ➊
and pull the adapter off towards you. Then reattach the worklight cover (7).
Operation
Starting Operation
Setting the Rotational Direction
The rotational direction switch (6) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (5) is
being pressed.
1 609 92A 6RC | (02.05.2022) Bosch Power Tools