If You Are Using The Powerstore T Model Appliance; If You Are Using The Powerstore X Model Appliance - Dell EMC PowerStore Quick Start Manual

Table of Contents

Advertisement

If you are using the PowerStore T Model appliance:

Cable the management interface on both nodes to a management switch or
Note: You will require two additional network cables to complete this step.
Note: For more detailed instructions on recommended networking configurations, including how to
configure PowerStore T with top-of-rack switches, see the
PowerStore T Models
determine which ports on your switches to use.

If you are using the PowerStore X Model appliance:

Using the supplied cables:
Connect the network cables on node A:
Connect the network cables on node B:
Note: These instructions show a minimum cabling configuration. For more detailed instructions on
recommended networking configurations, see the
at https://dell.com/powerstoredocs. Check with your network administrator to determine which ports on
your switches to use.
Dell EMC PowerStore Quick Start Guide
at
https://dell.com/powerstoredocs.
a.
Port 0 of the embedded module connects to switch 1.
b.
Port 1 of the embedded module connects to switch 2.
a.
Port 0 of the embedded module connects to switch 2.
b.
Port 1 of the embedded module connects to switch 1.
network.
PowerStore Networking Guide for
Check with your network administrator to
PowerStore Networking Guide for PowerStore X Models
Page 5 of 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EMC PowerStore and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Powerstore

Table of Contents