Table of Contents
Advertisement
The electrical supply must be a correctly polarized, grounded 120 V AC, 60 Hz, single phase
circuit suitable for the maximum current draw of the model, as detailed in the table below.
Please verify your model's current draw by checking the rating label on the rangetop.
Required grounding method
This appliance is factory equipped with a power supply cord with a three-prong grounding
plug (with polarized parallel blades). It must be plugged into a mating grounding type
receptacle, connected to a correctly polarized 120 Volt circuit. If the circuit does not have a
grounding type receptacle, it is the responsibility and obligation of the installer to have the
existing receptacle changed to a properly grounded and polarized receptacle in accordance
with all applicable local codes and ordinances by a qualified electrician. In the absence of
local codes and ordinances, the receptacle replacement shall be in accordance with the
National Electrical Code.
The third prong should not, under ANY circumstances, be cut or removed.
MODEL
CPV3-304
CPV3-366
CPV3-485GD
CPV3-486GD
CPV3-488
This cooktop must be grounded.
z
Always disconnect electric supply cord from the wall outlet or service disconnect before
z
servicing this appliance.
Observe all governing codes and ordinances when grounding, in absence of which, observe
z
National Electrical Code ANSI / NFPA No. 70.
VOLTAGE
MAX CURRENT
120 V
0.5 A
120 V
0.5 A
120 V
7 A
120 V
7 A
120 V
0.5 A
ELECTRICAL REQUIREMENTS
The rating label
is located on the
right-hand side
of the rangetop,
near the front.
MAX POWER
60 W
60 W
840 W
840 W
60 W
A wiring
diagram label
is attached to
the bottom of
the rangetop
11
Advertisement
Table of Contents
