Advertisement
Quick Links
Advertisement
Related Manuals for Champion Autolift FP8000
Summary of Contents for Champion Autolift FP8000
- Page 1 FP8000 Installation Manual ...
- Page 2 ATTENTION Please follow these instructions. The installation of your lift will take 4-5 hours. Do not rush. Take your time and do the job right. Use proper lifting devices and techniques to assemble the lift. Do not attempt to use the power unit to extend your cylinder.
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Read these safety instructions entirely! Failure to read these instructions may result in injury to user, other people within the area of the lift, or vehicles. We are not responsible for any injury or damage as a result of neglecting to carefully read and follow these instructions. ... - Page 4 DANGER! The power unit used on this lift contains high voltage. Disconnect power at the receptacle before performing any electrical repairs. Secure plug so that it cannot be accidentally plugged in during service. WARNING! RISK OF EXPLOSION. This equipment has internal arcing or sparking parts which should not be exposed to flammable vapors.
- Page 5 installation manual in its entirety before attempting to install or operate the lift. SELECTING SITE: B efore installing your new lift, check the following. OVERHEAD OBSTRUCTIONS : The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines ...
- Page 6 COLUMN & CROSSRAIL INSTALLATION L ay down rear columns. Position the crossrail at the top of the two columns. (both cross rails are the same ) Install the crossrail in the column by sliding the plastic guide blocks into the column channel.
- Page 7 brackets, wheel stops with 1 /2” x 4” bolts and nuts . After both tracks are installed, tighten all bolts 1/2” x 4” bolts - torque - 45 ft-lbs. Find the leg caps ( 4 each), 1/2” x 7” bolts (4 each), 1/2” x 1 1/4” bolts (4 each), 1/2”...
- Page 8 After you have extended the chrome rod, attach the cable to the top caps in the legs. Make sure each cable is on the pulleys. Place both nuts on top of the top cap and tighten them together. Safety Latch Linkage Installation: L ocate and identify the components needed to install the safety latch linkage rods.
- Page 9 Check the crossrail locking assembly before use. Make sure all bolts and collars are tight. The assembly is pre-installed from the factory but parts may come loose during shipping. After installation is completed, before start up, be sure to inspect and tighten all bolts. ...
-
Page 10: Pre-Operation Check
OPERATION Do not use this lift unless you know the proper operation of the lift and its safety devices, and the hazards involved. See Safety Instructions page 2. 1. Drive the vehicle onto lift platform. Set the vehicle’s parking brake and leave the transmission in park / gear. - Page 11 ...
- Page 12 ...
- Page 13 ...
- Page 14 www.championautolift.com 1.800.844.9608 ...