Table of Contents
Advertisement
Connecting water
1 Ensure the refrigerator is NOT plugged into a power supply. Locate the water supply
valve for cold water connection (Tee and tap fitting not supplied).
2 Locate the water hose set to complete the water connection installation.
3 Remove cap from water inlet valve at the back of the refrigerator A.
4 Connect one end of the water hose set to the water inlet valve b.
5 Push the plastic molded end (ferrule) into the water inlet valve. Tighten the compression
nut until it is hand tight, then tighten one additional turn with an adjustable spanner.
6 Connect the other end of the water hose set to the water supply valve c. Push the
plastic molded end (ferrule) into the water supply valve, tighten the compression nut
until it is hand tight. Tighten one additional turn with an adjustable spanner.
7 Check the connections, turn on the water supply and check for leaks.
INSTALLATION INSTRUCTIONS
A
Water inlet valve
Water hose set
B
Plastic
molded end
c
Water supply valve
9
Advertisement
Table of Contents
