Fisher & Paykel DW60FC User Manual page 11

SETTING WASH MODIFIERS (
Using sanitize
The sanitize wash modifier adjusts the wash programme to meet the conditions required
C2, C4 Dishwasher
by Section 6, NSF 184 for sanitization to occur.
While sanitize is running, the wash programme is monitored to ensure that these
conditions are met.
IMPORTANT!
For sanitization to occur, the temperature of the water needs to reach 70
●
Check that all items in the dishwasher are dishwasher safe before running the
sanitize modifier.
If the wash is interrupted or the water supply is turned off during the cycle, then the
●
heating conditions for sanitization may not be met. You may need to run the cycle
again to ensure sanitization of your dishes.
Only cycles utilising the sanitize wash modifier are designed to meet the conditions
●
required by Section 6, NSF 184. Other wash programs may not reach the temperatures
required for sanitization to occur. See table on previous page for wash programs that
have sanitize available
At the end of a wash programme with sanitize, always check the display to make sure
that sanitization has been successful.
If sanitization has been successful:
The dishwasher will beep
●
0
will show in the display
●
The sanitize indicator will remain lit.
●
After 30 seconds the display will turn off.
●
If sanitization has not been successful:
An alert will sound
●
An alert code will show in the display
●
The sanitize indicator will not be lit.
●
C2, C4 Dishwasher
DW60FC6 AND DW60UC6 MODELS
C6 Dishwasher
C6 D
)
C.
0
7