Temperature Limiting Control; Trouble Shooting; Cleaning - Hanover X19VWMEF1BLK Installation And Operation Instructions Manual

Table of Contents

Advertisement

This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature,
(115 degrees Celsius) the heater will automatically turn off. To reset: Unplug unit from wall, wait for 5 minutes,
plug back in and continue to use.
SYMPTOM
Fireplace
doesn't work.
Flame is not
moving.
Dim or poorly
visible flame or
glass pebbles
aren't glowing.
Flame sputters
Remote control
does not work.
Circuit breaker
trips or fuse
blows when the
unit is on.
Heater does not
provide heat
when turned
on.
Appliance turns
off and will not
turn on.
Turn heater OFF and unplug from outlet. Use a vacuum or duster to keep heat and vent area clean from
dust and dirt. The exterior should be cleaned with a damp cloth or duster. Do not use abrasive cleaners,
liquid sprays, or any other cleaner that may scratch the surface.

TEMPERATURE LIMITING CONTROL

TROUBLE SHOOTING

POSSIBLE CAUSES
Fireplace inner components
are overheating or the home
circuit breaker has tripped.
Wiring may be loose or the
flame motor may be
defective.
LED lights are burnt out or
the wiring is loose.
Flame motor is defective.
Low battery.
Master switch is in "OFF"
position.
Improper circuit current
rating.
Thermal switch has been
tripped. Circuit breaker has
been tripped.
Appliance has overheated
and its safety device has
caused the thermal switch to
disconnect.
House circuit breaker has
tripped.

CLEANING

CORRECTIVE ACTION
Reset switch by turning
master switch off and waiting
for 5mins, then turning it back
on.
Call customer service for
instructions.
Call customer service for
instructions.
Call customer service for
instructions.
Change the battery for
remote control. Check to
make sure the master switch
is turned on.
Call customer service for
instructions.
Turn the unit off and unplug
the unit for 5mins. Plug back
in and turn on the unit.
Turn off circuit breaker that
supplies electricity to the unit,
wait 5mins, then flip circuit
breaker back on.
Unplug the appliance, allow
to cool for 15mins, then plug
back in.
Reset the house circuit
breaker.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

X19vwmef1wht

Table of Contents