Parameter Setting - Elitech STC-1000Pro TH Quick Start Manual

3.3 Parameter Setting

Press and hold
the buzzer will beep, and the LCD will display
In the menu setting, press
or flashes. When it is flashing, press
parameter; when the parameter light is on, press
or decrease the setting value.
In the menu setting, press and hold
and exit; or the controller will save and exit setting mode after 30 seconds of idle.
The Tsv displays temperature-related parameters and Hsv displays humidity-
related parameters.
For example, set TS and TD parameters into TS = 20°C and TD = 5°C respec-
tively.as shown in Fig. 6.
① Press
button and release after the buzzer beeps (about 3 seconds);
② Press
button, and the parameter code will display TS;
③ Press
button, and will flash, indicates TS parameter is ready
to be set;
④ Press (or press and hold)
⑤ Press
button, and TPV will appear;
⑥ Press
button, and the parameter code will display TD;
⑦ Press
button, and TPV will flash,indicates TD parameter is ready
to be set;
⑧ Press (or press and hold)
⑨ Press
button and release after the buzzer beeps (about 3 seconds)
to exit the parameter setting.
Note: Dotted-line in the figure shows the numbers are flashing (ready for
setting); solid-line shows the numbers stop flashing (value is set).
See the flow chart below to change other parameter values one by one.
as shown in Fig. 7.
button for 3 seconds to enter the parameter setting mode,
button and the Tsv
button to change the value to 20;
or button to switch to the next
button for 3 seconds to save settings
button to change the value to 5;
-7-
icon.
parameter light will be on
3
or button to increase