Table of Contents
Advertisement
Installation Procedure
Setting Option
1 Remove batteries from the remote controller
2 Insert batteries and enter the option setting mode while pressing button and button.
3 Each time you press button, 7-seg on left side is increased by "1" and each time you press button, 7-seg on right
side is increased by "1"
4 You press button to move to the next setteing page.
5 After setting option, press button to check whether the option code you input is correct or not.
→
→
6 Press operation button
CAUTION
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
• Set the SEG1, SEG7 as ON status and SEG13, SEG19 as OFF status.
‐ Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting
option at the same time.
The procedure of setting option
Step 1
1 Remove the batteries from the remote controller.
2 Insert batteries while pressing Button and Button.
Step 2
1 Press button to enter SEG2 value.
2 Press button to enter SEG3 value.
Step 3
Press button to be change to Cool mode in the ON status.
1 Press button to enter SEG4 value.
2 Press button to enter SEG5 value.
30
English
→
→
→
→
with the direction of remote control for set.
Operation
→
→
Indication
Advertisement
Table of Contents
