Table of Contents
Advertisement
WAGO Gateway Installation and Service
Intended Use
Intended use
The gateway is only intended to be installed and operated
in conjunction with Viessmann control units, with
due attention paid to the associated installation, service
and operating instructions. The gateway may only
be used in systems with supported Viessmann heat
and power generators.
The gateway can only be used with the user and
communication interfaces defined in the product
documentation for the following purposes:
H To monitor systems
H To operate systems
H To optimize systems
Product Information
Spare Parts Lists
With regard to the communication interfaces, ensure on
site that the system requirements specified in the product
documentation are met at all times for every transfer
medium employed. Only use the specified components for
the power supply (e.g. power supply units).
Intended use presupposes that a fixed installation in
conjunction with permissible, system-specific components
has been carried out.
Commercial or industrial use for a purpose other than
the monitoring, operation and optimization of supported,
approved systems shall be deemed inappropriate.
Incorrect usage or operation of the appliance (e.g. the
appliance being opened by the system user) is prohibited
and will result in an exclusion of liability. Incorrect
usage also occurs if the components in the Viessmann
system are modified from their intended function.
The WAGO BACnet/IP gateway is used to connect
Viessmann control units to BACnet systems.
For supported devices and other valid product
documentation, use the QR code on the left.
Functions
The system user can use the following functions via
the gateway when connected to a BACnet system:
H Transferring heating system operating states
H Setting heating system parameters
H Relaying fault and maintenance messages
Information about spare parts can be found at
www.viessmann.com/etapp or in the Viessmann
spare part app.
Installation
5
Advertisement
Table of Contents
