WAGO Gateway Installation and Service
Process Overview
Step
1
Install the module.
2
Establish the CAN bus connection.
3
Connect the plug-in attachment.
4
Establish the connection to the BACnet.
5
Power supply
6
Commission the gateway.
Installing the Module
Overview of connecting cables
Connecting cables
Accessories:
CAN bus cable
Responsibility
Contractor
Contractor
Contractor
IT expert/system integrator
Electrician
IT expert/system integrator
IMPORTANT
Incorrect ambient conditions and installation locations may
impair data transfer and cause damage to the gateway.
Ambient conditions during operation
H Permissible ambient temperature:
32 to 102°F (0 to 40°C)
H Permissible relative humidity:
– 32 to 102°F (0 to 39°C): ≤ 95%
– ≥ 104°F (40°C): ≤ 50%
H No direct sunlight
IMPORTANT
Operation by unauthorized persons may result in damage
to the system. Access to the gateway must only be
possible for authorized specialists with a key or tool.
Length
23 ft. (7 m)
Installation
Page
6
12
14
15
17
18
11