Process Overview; Installing The Module - Viessmann WAGO MB/TCP Installation And Service Instructions Manual
Bms communication with heating systems via modbus
Hide thumbs
Also See for WAGO MB/TCP:
Table of Contents
Advertisement
Installation
Installation
Process Overview
Step
1
Establish the CAN bus connection.
2
Connect the plug-in attachment.
3
Establish the connection to the Modbus.
4
Power supply
5
Commission the gateway.
Installing the Module
Overview of connecting cables
Connecting cables
Accessories:
CAN bus cable
8
WAGO Gateway Installation and Service
Responsibility
Contractor
Contractor
IT expert/system integrator
Electrician
IT expert/system integrator
IMPORTANT
Incorrect ambient conditions and installation locations may
impair data transfer and cause damage to the gateway.
Ambient conditions during operation
H Permissible ambient temperature: 32 to 104°F
(0 to 40°C)
H Permissible relative humidity:
– 32 to 104°F (0 to 39°C): ≤ 95%
– ≥ 104°F (≥ 40°C): ≤ 50%
H No direct sunlight
IMPORTANT
Operation by unauthorized persons may result in damage
to the system. Access to the gateway must only be
possible for authorized specialists.
Length
23 ft. (7 m)
Page
13
15
16
17
18
Advertisement
Table of Contents
